Fisker Ocean Ambient Temp Replacement Harness Connector with PINS

Fisker Ocean Ambient Temp Replacement Harness Connector with PINS

This connector commonly gets water inside and corrodes.  Once corrosion sets in the wires do not get a good connection to the Ambient Temperature Sensor. Symptoms are Radiator Fan running full blast when the car is locked and not being used or being charged. Also running FAN full blast while car is functioning. This can put a lot of stain on the 12v system and cause premature battery failed and severe vampire drain on the HV system. 

This is for Quantity of 1 Connector Plug with PINS and the Wire Seals.

Recommended next steps after crimping this on your old wires is to plug it in and test if symptoms go away. If they do then use silicone tape to seal up the harness connection to the sensor and then use wire loom tape over top. Do not use electrical tape as it will come loose due to heat and weather exposure 

Silicone Tape Link

https://amzn.to/4edg64F

Wire Loom Tape Link

3 Pack - https://amzn.to/4o9FU5Y

5 Pack - https://amzn.to/4odeZWV

Crimper Tool Link

https://amzn.to/4dSEKbJ

Disclaimer

Electrified Ocean and Chad Sturgill are not responsible for any damage to your Fisker Ocean or any personal injury that may occur from the use or attempted installation of this device. By purchasing or using this device, you agree to hold harmless and indemnify Electrified Ocean and Chad Sturgill from any and all claims, damages, or liabilities arising from its installation or use, including but not limited to personal injury, property damage, or vehicle malfunction.