Fisker Ocean Ambient Temperature Sensor

Fisker Ocean Ambient Temperature Sensor

Note: This sensor runs about 3° warmer than OEM. 

Sensor is located behind main grill in the front bumper directly behind the main central ADAS Radar. When these sensors go out the radiator fan will kick on high and run full blast cycling on and off every few minutes. If the harness is corroded, it likely has affected the sensor pins as well. It is recommended to replace both if the pins are corroded. Sometimes animals also get into that area and nibble the wires. Check with a flashlight to see if you can visually see wires going up to the sensor. If not then you likely only need the replacement harness connector which is also sold here on Electrified Ocean.  

Recommended next steps after installing the module is to plug it in and test if symptoms go away. If they do then use silicone tape to seal up the harness connection to the sensor and then use wire loom tape over top. Do not use electrical tape as it will come loose due to heat and weather exposure 

Silicone Tape Link

https://amzn.to/4edg64F

Wire Loom Tape Link

3 Pack - https://amzn.to/4o9FU5Y

5 Pack - https://amzn.to/4odeZWV

Crimper Tool Link

https://amzn.to/4dSEKbJ

Disclaimer

Electrified Ocean and Chad Sturgill are not responsible for any damage to your Fisker Ocean or any personal injury that may occur from the use or attempted installation of this device. By purchasing or using this device, you agree to hold harmless and indemnify Electrified Ocean and Chad Sturgill from any and all claims, damages, or liabilities arising from its installation or use, including but not limited to personal injury, property damage, or vehicle malfunction.