Siren Module shown for demonstration and is not included! Only the cover is included in this purchase.
3D Printed cap to cover the siren that sits under the fuse box under the hood. It snaps in good but in warmer weather it can come loose so it’s best to put some electrical loom tape on it to hold It in place.
It can be put on without removing the siren. However it is easy to remove. You take out the 3 nuts holding down the fuse box and under it is another nut that holds the siren mounted below the plate. Be aware that unplugging the siren may make it go off. Be ready to snap in the silencer as soon as you unplug the harness. Once you get the cover snapped in, put some electrical loom tape on it. If you want a more permanent solution you can also super glue or use silicone to adhere the cover to the siren more permanently.
Disclaimer
Electrified Ocean and Chad Sturgill are not responsible for any damage to your Fisker Ocean or any personal injury that may occur from the use or attempted installation of this device. By purchasing or using this device, you agree to hold harmless and indemnify Electrified Ocean and Chad Sturgill from any and all claims, damages, or liabilities arising from its installation or use, including but not limited to personal injury, property damage, or vehicle malfunction.
